Decorative Concrete of Austin
Austin, TX, USA
4. We’ve uncovered that installing the sheets vertically is A lot easier than horizontally. We utilized to do them horizontally but hey have an inclination to ‘tumble’ ahead of the adhesive dries.
Phil – I can show you we’ve finished several basements in this way plus they all have labored incredibly perfectly. For me The main element is often sealing the foam correctly. I remarkably advocate Tyvek tape since it seals VERY nicely to foam board. You'll be able to seal around the perimeter with spray foam.
Maybe I’m just overthinking this, but I actually need my basement to not scent like, properly, a basement. The more I learn the greater bewildered I get as all the locals seem to have different viewpoints.
Kristi, I've an issue. Can you place the obvious coat appropriate along with the concrete without the white plastic layer plus the painted layers so the concrete exhibits via more?
It appears to me that anything like Dricore doesn’t offer you enough insulation to prevent condensation, and an entire one.five inches of froth for just a vapor barrier just will get for being far too superior. But on the other hand, I actually don’t determine what I’m accomplishing in addition to what I’ve read below and somewhere else…
Elizabeth – That technique Seems high-quality. I'd swap the Hardibacker for Ditra (). It’s easier to perform with, warmer, and an all around better tile backer for my part.
Seal many of the seams with the foam board insulation. We advocate you tape the seams with Tyvek (or similar) tape. You'll be able to seal along the walls with spray foam from a can (Wonderful Stuff or related).
one. For those who’re concerned about top than taking away the tile might help. I’m unsure it’s Unquestionably necessary to remove it.
I'm positive the bottom is moist, but I resloped my landscaping just before putting up the foam board, and my house is near the highest of the hill… I also set two coats of Drylok on the wall. So the problem just isn't standing water driving in.
I have rented a twin disc grinder with the appropriate tips but this didn’t do the job way too well. The stripper I attempted didn’t do the job possibly.
I can inform you just how much mine cost, but not surprisingly, that doesn’t suggest that it’ll be a similar price in your area.
Considering you cutting concrete around a pool say ceiling top and cost are your largest concerns I’d use anything like DRIcore. It works quite effectively, it will make the floor feel warmer and I’ve had fantastic results with it.
Some irregular formed or oversized items might incorporate a Distinctive handling charge. The demand will info about decorative concrete austin demonstrate around the solution detail page of relevant products. Give subject to vary without detect.
He stated he thinks that’s fantastic, but he’s planning to double check for me. The Stonelok countertop sealer, that's epoxy/urethane, is Protected up to 400 levels. So if that will handle higher warmth, I’m Practically particular which the polyurea can likewise. But once more, he’s cutting a concrete slab verifying that facts for me.